Fit the large projection [A] of the socket into the large
groove [B] of the turn signal light.
Turn the rear turn signal light bulb clockwise.
Turn Signal Relay Inspection
Remove the front center cover (see Front Center Cover
Removal in the Frame chapter).
Pull out the turn signal relay [A] backward, and remove it
from the rear fender.
Disconnect the connector.
Connect one 12 V battery and turn signal lights as indi-
cated, and count how many times the lights blink for one
Turn Signal Relay [A]
Turn Signal Lights [B]
12 V Battery [C]
Battery (+) → BK lead terminal
Turn Signal Lights → GY lead terminal
If the lights do not blink as specified, replace the turn sig-
Testing Turn Signal Relay
The Number of Turn
(*): Cycle(s) per minute
(**): Corrected to "one light burned out".
Hazard Control Unit Removal
Remove the rear fairing (see Rear Fairing Removal in the
Disconnect the connector [A].
Remove the hazard control unit [B].
Hazard Control Unit Installation
Installation is the reverse of removal.
150 ∼ 250
70 ∼ 100
ELECTRICAL SYSTEM 16-43