Check that the dowel pins [A] are in place on the
Replace the alternator cover gasket with a new one.
Tighten the alternator cover bolts together with the
Torque - Alternator Cover Bolts: 9.8 N·m (1.0 kgf·m, 87
Run the lead and water hoses correctly (see Cable, Wire,
and Hose Routing section in the Appendix chapter).
Torque - Water Hose Clamp Screws: 4.4 N·m (0.45 kgf·m,
Install the removed parts (see appropriate chapters).
Stator Coil Removal
Alternator Cover (see Alternator Cover Removal)
Crankshaft Sensor Bolts [A]
Crankshaft Sensor [B]
Alternator Lead Grommet [C]
Stator Coil Bolts [D]
Remove the stator coil [E] from the alternator cover.
Stator Coil Installation
Install the stator coil and crankshaft sensor, and tighten
Torque - Stator Coil Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Crankshaft Sensor Bolts: 4.4 N·m (0.45 kgf·m, 39
Using a high flash-point solvent, clean off any oil or dirt
that may be on the liquid gasket coating area. Dry them
with a clean cloth.
Apply liquid gasket to the circumference of the alternator
lead grommet, and fit the grommet into the notch of the
Sealant - Liquid Gasket, TB1211F: 92104-0004
Install the alternator cover (see Alternator Cover Installa-
Alternator Rotor Removal
Remove the alternator cover (see Alternator Cover Re-
Hold the alternator rotor steady with the flywheel holder
[A], and remove the rotor nut [B] and washer.
Special Tool - Flywheel Holder: 57001-1313
Do not hold the rotor at pick-up portion with the fly-
ELECTRICAL SYSTEM 16-23