16-22 ELECTRICAL SYSTEM
Alternator Cover Removal
Engine Oil (see Engine Oil Change in the Periodic Main-
Coolant (see Coolant Change in the Periodic Mainte-
Storage Box (see Storage Box Removal in the Frame
Lower Fairing (see Lower Fairing Removal In the Frame
Exhaust Pipe (see Exhaust Pipe Removal in the Engine
Top End chapter)
Remove the band [A] and slide the dust cover [B].
Open the clamp [C].
Crankshaft Sensor Lead Connector [D]
Alternator Lead Connector [E]
Open the water hose clamp and disconnect the water by-
pass hose [A].
Loosen the water hose clamp screws and disconnect the
water hoses [B].
Alternator Cover Bolts [C]
Alternator Cover [E]
Alternator Cover Installation
Using a high flash-point solvent, clean off any oil or dirt
that may be on the liquid gasket coating area. Dry them
with a clean cloth.
Apply liquid gasket to the alternator lead grommet [A] on
the alternator cover.
Sealant - Liquid Gasket, TB1211F: 92104-0004
Replace the O-rings [B] with new ones.
Apply grease to the new O-rings.