Anti-Lock Brake System (Equipped Model)
ABS Hydraulic Unit Removal
The ABS hydraulic unit [A] has been adjusted
and set with precision at the factory. Therefore, it
should be handled carefully, never struck sharply,
as with a hammer, or allowed to fall on a hard
surface.
Be careful not to get water or mud on the ABS hy-
draulic unit.
•
Drain the brake fluid from the front and rear brake lines.
○
Drain the brake fluid through the bleed valve by pumping
the brake lever and pedal.
•
Clean the ABS hydraulic unit.
Clean all fittings on the ABS hydraulic unit and the
rear master cylinder because dirt around the banjo
bolts could contaminate the brake fluid in the line
during removal/installation.
Spread over a shop towel around the ABS hydraulic
unit before removing the brake line so that brake
fluid does not leak on the parts.
•
Open the clamp [A].
•
Pull the lever [B] upward to disconnect the ABS hydraulic
unit connector [C].
•
Remove:
Brake Pipe Banjo Bolts [A]
Brake fluid quickly ruins painted plastic surfaces;
any spilled fluid should be completely washed away
immediately.
•
Remove the bolts [A].
•
Clear the projection [B], and remove the ABS hydraulic
unit [C] together with the bracket.
NOTICE
NOTICE
NOTICE
BRAKES 12-39
Comments to this Manuals
Latest comments: