Apply molybdenum disulfide oil solution to the piston and
Apply molybdenum disulfide oil solution to the piston rings
(see Piston Installation).
Install the cylinder while compressing the piston rings with
Install the lower camshaft chain guide [A] securely.
Fit the projections [B] to the grooves [C].
Tighten the cylinder bolts temporary.
Install the removed parts (see appropriate chapters).
Remove the cylinder (see Cylinder Removal).
Place a clean cloth under the piston.
Remove the snap ring [A].
Piston pin [A]
Carefully spread the piston ring opening with your thumbs
and then push up on the opposite side of the ring [A] to
Remove the 3-piece oil ring with your thumbs in the same
Apply molybdenum disulfide oil solution to the oil ring ex-
pander, and install the oil ring expander [A] in the bottom
piston ring groove so the ends [B] butt together.
Apply molybdenum disulfide oil solution to the oil ring steel
rails, and install the oil ring steel rails, one above the ex-
pander and one below it.
Spread the rail with your thumbs, but only enough to fit
the rail over the piston.
Release the rail into the bottom piston ring groove.
The oil ring rails have no "top" or "bottom".
ENGINE TOP END 5-29