4-14 COOLING SYSTEM
Install the cap [A] on a cooling system pressure tester [B].
Wet the cap sealing surfaces with water or coolant to
prevent pressure leaks.
Watching the pressure gauge, pump the pressure tester
to build up the pressure until the relief valve opens: the
gauge needle flicks downward. Stop pumping and mea-
sure leak time at once. The relief valve must open within
the specified range in the table below and the gauge hand
must remain within the same range for at least 6 seconds.
Radiator Cap Relief Pressure
88 ±14 kPa (0.9 ±0.15 kgf/cm², 13 ±2 psi)
If the cap can not hold the specified pressure or if it holds
too much pressure, replace it with a new one.
Radiator Filler Neck Inspection
Front Center Cover (see Front Center Cover Removal in
the Frame chapter)
Check the radiator filler neck for signs of damage.
Check the condition of the top and bottom sealing seats
[A] in the filler neck. They must be smooth and clean for
the radiator cap to function properly.