Water Pump Cover Removal
Drain the coolant (see Coolant Change in the Periodic
Right Lower Fairing (see Lower Fairing Removal in the
Exhaust Pipe (see Exhaust Pipe Removal in the Engine
Loosen the water hose clamp screw and disconnect the
water hose [A].
Open the water hose clamp and disconnect the water by-
pass hose [B].
Water Pump Cover Bolts [C]
Water Pump Cover [D] and Gasket
Water Pump Cover Installation
Replace the water pump cover gasket with a new one.
Install the dowel pins [A] and new gasket are in place.
Install the water pump cover and tighten its bolts.
Install the water hoses.
Torque - Water Hose Clamp Screw: 4.4 N·m (0.45 kgf·m, 39
Install the removed parts (see appropriate chapters).
Fill the cooling system with the coolant (see Coolant
Change in the Periodic Maintenance chapter).
Water Pump Cover (see Water Pump Cover Removal)
Water Pump Impeller [A] and Washer
Water Pump Impeller is left-hand threads.
If necessary, hold the alternator rotor bolt [A] to remove
the water pump impeller.
When the alternator cover center cap is removed, replace
the O-ring of the cap with a new one.
Installation is the reverse of removal.
Torque - Water Pump Impeller: 12 N·m (1.2 kgf·m, 106 in·lb)
COOLING SYSTEM 4-9