Table of Contents
Advertisement
HP AdvanceStack Switch
10Base-FL Module
For the HP AdvanceStack Switch 2000
At A Glance
The HP AdvanceStack 4-Port 10Base-FL Module (HP J3109A) is an optional
component that you can add to an HP AdvanceStack Switch 2000 to provide
four 10Base-FL ports.
Connector
Extractor Handle
The HP AdvanceStack 4-Port 10Base-FL Module
Features: The HP AdvanceStack 10Base-FL Module can enhance your Switch
2000 in the following ways:
You can add 10Base-FL modules without shutting down the entire switch.
(Adding a new module requires a simple reset of the switch—turning off
the power is not necessary.)
You can install up to six 10Base-FL Modules in your Switch 2000, enabling
you to "fully load" the switch with up to 24 Ethernet/IEEE 802.3j ports.
You can also install various combinations of modules, as described in the
Note on page iv.
10Base-FL Ports
Extractor Handle
Advertisement
Table of Contents
