Table of Contents
Advertisement
3-5 Paraphonic Mode
You can activate paraphonic ( 3 voice) mode at any time by holding a waveform
button on voice 1 for 4 seconds. The LED displays PA indicating Paraphonic
mode. Voices 2 and 3 and now mirror the parameters of voice 1 but can also be
changed individually.
TherapSid always orders notes from voice 1 to voice 3 so you can hold a 2 note
chord with voices 1 and 2, and play a melody with voice 3 for example
Hold a waveform button on voice 1 again for 4 seconds to go back to
Monophonic Mode
3-6 Glide
Adds glide aka portamento to the synth's pitch.
More glide=longer portamentos/slides.
3-7 Sync
When set on voice1, Synchronizes the fundamental frequency of Oscillator 1
with the fundamental frequency of Oscillator 3, producing "Hard Sync" effects.
Varying the frequency of Oscillator 1 with respect to Oscillator 3 produces a
wide range of complex harmonic structures from Voice 1 at the frequency of
Oscillator 3. In order for sync to occur Oscillator 3 must be set to some
frequency other than zero but preferably lower than the frequency of Oscillator
1. No other parameters of Voice 3 have any effect on sync.
3-8 Ring Mod
When set, replaces the Triangle waveform output of Oscillator 1 with a "Ring
Modulated" combination of Oscillators 1 and 3. Varying the frequency of
Oscillator 1 with respect to Oscillator 3 produces a wide range of non-harmonic
overtone structures for creating bell or gong sounds and for special effects. In
order for ring modulation to be audible, the Triangle waveform of Oscillator 1
must be selected and Oscillator 3 must be set to some frequency other than
zero. No other parameters of Voice 3 have any effect on ring modulation.
6 of 18
Advertisement
Table of Contents
