Torch Maintenance - Eastwood TIG200 Instructions Manual

WELDER CARE & MAINTENANCE
• Constantly inspect the torch tip for excessive erosion, molten metal accumulation burning. If damaged, it must be replaced.
• Before each use, inspect ALL electrical connections, cables, supply line, torch, air supply, housing and controls for damage. If any damage or wear is
noted, DO NOT USE THE UNIT.
• If the welder requires service, it should be performed by a certified repair facility using only authorized replacement parts to maintain full safety and
performance integrity of the welder.
• Always store the unit in a safe, clean and dry environment.

TORCH MAINTENANCE

ELECTRIC SHOCK CAN CAUSE INJURY OR DEATH!
Disconnect welder from power supply before assembly, disassembly or maintenance of the torch, contact tip and when installing
or removing nozzles.
The Eastwood TIG 200 has a number of consumable parts that will need to be replaced over time. If wear or slag build up is noticed on any of the torch compo-
nents, replace them immediately to avoid damage to the torch. Worn components will also contribute to poor performance. See the torch components (FIG. H)
exploded view for a reference of all of the components and the assembly order.
12