Download  Print this page

Cleaning The Pre-filter - Philips AC2885 User Manual

Hide thumbs

Advertisement

Note
• If the air purifier is used in a dusty
environment, it may need to be
cleaned more often.
• If the humidity level in the room is
very high, condensation may develop
on the air quality sensor and the air
quality light may indicate a more poor
air quality even though the air quality
is actually good. If this occurs, clean
the air quality sensor or use the air
purifier on a manual speed setting.
1
Switch off the air purifier and
unplug from the wall outlet.
2
Clean the air quality sensor inlet
and outlet with a soft brush (fig.u).
3
Remove the air quality sensor cover
(fig.v).
4
Clean the air quality sensor, the
dust inlet and the dust outlet with a
damp cotton swab (fig.w).
5
Dry all parts thoroughly with a dry
cotton swab.
6
Reattach the air quality sensor
cover (fig.x).

Cleaning the pre-filter

Clean the pre-filter when F0 is displayed
on the screen(fig.y).
1
Switch off the air purifier and
unplug from the wall outlet.
2
Pull the bottom part of the front
panel to remove it from the air
purifier (fig.c).
3
Press the two clips down (1) and
pull the pre-filter towards you (2)
(fig.d).
4
If the pre-filter is very dirty, use a
soft brush to brush away the dust
(fig.z). Then wash the pre-filter
under running tap water.
14
EN
5
Allow the pre-filter to air dry
thoroughly before placing back in
the air purifier.
Note
• To optimize the lifetime of the pre-
filter, make sure it air dries completely
after cleaning.
• Wash your hands after handling the
filter.
6
Put the pre-filter back into the air
purifier (fig.h).
Note
• Make sure the side with the two clips
is pointing towards you, and that all
hooks of the pre-filter are properly
attached to the air purifier.
7
To reattach the front panel, press
the top part of the panel onto the
top of the air purifier (1). Then,
gently push the panel against the
body of the air purifier (2) (fig.i).
8
Put the plug of the air purifier in the
wall outlet.
9
Touch and hold the reset button
for 3 seconds to reset the pre-filter
cleaning time (fig.{).
10
Wash your hands thoroughly after
installing filters.

Advertisement

Chapters

Table of Contents

This manual is also suitable for:

Ac2889

Comments to this Manuals

Symbols: 0
Latest comments: