Spring Clamp Terminal Block - Mitsubishi Electric QX10 User Manual

9 SPRING CLAMP TERMINAL BLOCK

9. SPRING CLAMP TERMINAL BLOCK
9.1 Q6TE-18S
The Q6TE-18S shall be used attached to a Q Series terminal block type I/O module or
an intelligent function module.
Since the Q6TE-18S uses a spring clamp it does not require screw tightening, which
greatly reduces the number of wiring procedures.
(1)
Model type
QX10
I/O module
QY10
QY70
Q62DA
Intelligent function
Q64AD
module
Q64TCRT
The terminal numbers of the Q6TE-18S correspond to the terminal numbers on the
compatible module.
For the signal names corresponding to the terminal numbers when connected to an
external device, please refer to the User's Manual of the module to use.
(2)
Applicable wire size
Wire strip length
Mounting screw tightening torque range
Weight
(3) Removal of Terminal Block and Installation of Q6TE-18S
9 - 1
Compatible Models
The QT6E-18S can be used with the following models:
QX28
QY18A
QY80
Q64DA
Q68ADV
Q64TCRTBW
POINT
Specifications
Item
(a) Removal of terminal block
! Unscrew the two terminal block mounting screws situated at the top and
bottom of the terminal block.
! Gently remove the terminal block.
Model name
QX40 QX40-S1
QY22 QY40P
QX48Y57 QI60
Q68DAV Q68DAI
Q68ADI
Q64RD
0.3 to 1.5 mm
8 to 11 mm
66 to 89 N!cm
0.07kg
Module
Terminal
block mounting
screw
Terminal block
MELSEC-Q
QX70 QX80
QY50 QY68A
Specifications
2
(AWG22 to 16)
9 - 1
9