Cabling The Drives For S140 - Dell PowerEdge User Manual

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage
due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
NOTE: For information on removing and reinstalling system parts, see the PowerEdge systems owner's manuals at dell.com/
poweredgemanuals.
This section provides details about the cabling information for the integrated PERC S140 controller.
NOTE: For information about cabling SATA and NVMe PCIe SSDs for S140, see your system owner's manual at dell.com/
poweredgemanuals.
1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior
of the system.
2 Remove the system cover.
3 Locate the connectors J_SATA A and J_SATA B on the system board.
4 Connect the J_SATA A and J_SATA B connectors on the AHCI devices to the corresponding cable connectors on the backplane using
the SATA cables.
NOTE: The first AHCI device provides connectivity to the drives available on port 0–5 and the second AHCI device
provides connectivity to the drives available on port 6–13. For information about disk connectivity for AHCI devices, see
Disk connectivity for AHCI
5 Install the system cover.
6 Turn on the system.
18

Cabling the drives for S140

Cabling the drives for S140
devices.
4