Table 2: Network Uses Static Ip Addresses; Port Information - Pitney Bowes DM SERIES AW20905 Configuration Manual

Table 2: Network Uses Static IP Addresses

DM500 through DM1000
1. Press the Menu key on the meter
2. Choose Set up
3. Choose Phone/Network Set Up
4. Choose More Options (down arrow)
5. Choose Network Settings
6. Choose Mailing System Network Settings
7. Choose Get IP Address
8. Choose Specify an IP Address
9. Choose IP Address, press the Clear key and
then enter the value determined by your network
administrator. Press the Enter key to accept
10. Choose Subnet Mask, press the Clear key and
then enter the value determined by your network
administrator. Press the Enter key to accept
11. Choose Default Gateway, press the Clear key
and then enter the value determined by your
network administrator. Press the Enter key to
accept
12. Choose Exit Set up

Port Information

DM Series™ Mailing Systems require opening Port 80 (HTTP) and Port 21 (FTP) for communications
to Pitney Bowes Servers. Port 80 is used to communicate XML formatted messages requesting services
from Pitney Bowes' postal and services related Servers. Port 21 is used to transmit new software and
graphics to the meter.
Other ports are used, and must be opened, depending upon additional packages that may be used in
conjunction with the meter. This will be covered in separate documents available with the purchase of
these options from Pitney Bowes. Available add-on packages include:
• Business Manager – Business Manager Configuration White Paper
• DFWorks™ – Systems Configuration – Network Ports Configuration
All rights reserved. No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical
(including photocopying, recording, or by any information storage retrieval system), without the owner's express written permission.
DM300c through DM450c
1. Press the Menu key
2. Choose Data Center Options
3. Choose Network Settings
4. Choose Get IP
5. Choose Specify Address Manually
6. Choose IP Addr, press the Clear key and then
enter the value determined by your network
administrator. Press the enter key to accept
7. Choose Subnet, press the Clear key and then
enter the value determined by your network
administrator. Press the enter key to accept
8. Choose Gateway, press the Clear key and then
enter the value determined by your network
administrator. Press the enter key to accept
9. Press the Enter key to save your changes
10. Press the Home key to return to the Mail Run
Screen
6
AW20905 Rev. A