Hose Connections - Dräger Oxylog 3000 plus Instructions For Use Manual

Assembly

Hose connections

B
B
1 Connect the breathing hose (A) to the breathing
valve.
2 Connect the flow measuring lines (B) to the noz-
zles on the flow sensor. Note the different diam-
eters of the hoses and the nozzles when
connecting the flow measuring lines and con-
nect to the correct side.
44
A
A
B
3 Connect the flow measuring lines (A) to the
Oxylog 3000 plus. Correct alignment is
indicated by a notch on the connector, which
must point away from the breathing hose.
Otherwise, the set will not fit and the measured
values will be incorrect.
4 Connect the breathing hose (B) to the gas outlet
on the Oxylog 3000 plus.
When connecting a hose, check that the hose
setting in the Settings window corresponds to the
connected hose.
Instructions for Use Oxylog 3000 plus SW 1.n