Download Print this page

Cutting Operations - Husqvarna MS 355 Manual

Hide thumbs

Advertisement

Wet
Fill the water reservoir
the water
intake Strainer (S) (Figure 6 -
Model) or Electric Water Pum Intake (U) (Figure
-
E
e l
c
r t
c i
M
o
d
e
i ) l
f s
l l u
the intake screen of these items clean and free
y
Dry
WARNING: Conventional "Wet" diamond blades
MUST be used with water. DO NOT use conventional
"Wet" diamond blades without water. Using con-
ventional "wet" diamond blades without water can
result in injury or death of the operator or persons
in the work area!
W
A
R
N
N I
G
:
W
h
e
diamond blades that are intended to be used dry
(without water). Conventional "Wet" diamond
blades MUST be used with water.
Hint: To reduce vibration of the saw, the water
to remove the Water
water
intake Strainer (S) (Gasoline Model) to avoi
WARNING: Always use respiratory protection
when dry sawing.
Electric Model (Figure 5):
Before cutting dry
Gasoline Model (Figure 8):
CAUTION: DO NOT run the Water Pump (U) for
extended periods of time without water! The
Water Pump could be damaged!
[Pan Weldment (A)] wit
i y
m
m
e
s r
e
d
n i
w
t a
r e
t a
n
c
u
t t
n i
g
w
i
h t
o
t u
w
t a
r e
(U) (Electric Models) or
the Water P
(U) from th

CUTTING OPERATIONS:

Place material on Conveyor Cart (C) and move conveyo
cart to the front of the saw so that the blade DOES NOT
Cutting Methods: This unit allows three methods for
l a
i t l
m
e
s
Fixed Head: Position the head to the desired height
then tighten the Lock Handle (P) (Figures 5 &
the material (See
Push the
to lower the blade into the
Start / Stop (Electric Models):
u
s
e
o
n
y l
O
Start the electric motor by turning the Power Switch (RR
the material using one of the Cutting Methods de-
WARNING: Keep hands clear of rotating
blade during operation. READ ALL SAFETY
WARNINGS before operating this machine.
CAUTION: DO NOT cut into the cast aluminum
area of the Conveyor Cart (C). The blade
should only cut into the wooden insert area of
Conveyor Cart (C)!
STOPPING THE UNIT (Electric Models):
St
to the OFF
movement to
Start / Stop (Gasoline Models):
the Primer Bulb until water
the engine by using the
at full
setting — it is factory set for the correct
WARNING: Keep hands clear of rotating
blade during operation. READ ALL SAFETY
WARNINGS before operating this machine.
A
Cut the material using one of the Cutting Method
the Hand
(UU) and lower the blade
Foot Pedal Kit (F)
the unit by turning the Power Switch (RR
before removing material
the Water Valve (T)
(U) using the Primer Bulb (V)
the engine throttle full
DO NOT change the engine
The blade will return
1) with your
The blade will
9) Wait for all
and
the W
through the
in the
All sawing is
19

Hide quick links:

Advertisement

loading

  Also See for Husqvarna MS 355

This manual is also suitable for:

Ms 355g