Listening To The Radio; Improving Stereo Fm Sound; Listening To A Connected Component - Pioneer X-MT2000 Operating Instructions Manual

4 Getting Started
STANDBY
1
2
STANDBY/ON
BASS/TREBLE
3
CD SELECT OPEN/CLOSE
FUNCTION
DISPLAY/
CLOCK
TIMER
ENTER (DEMO)
FUNCTION dial
FM/AM
AUX TUNER
4
REMOTE CONTROL UNIT
18
En

Listening to the radio

The tuner can receive FM and AM broadcasts, and lets you save your favourite stations so
TUNING
) ! ⁄
you don't have to manually tune in every time you want to listen.
$ ›
) &
) #*
1 Press FM/AM TUNER (remote)
If the system was in standby, the power comes on and the display shows the current band
and frequency. Use the
• If you're using the front panel, turn the
radio.
VOLUME
2 Tune to a station.
There are four tuning modes: preset, step and auto and hi-speed tuning.
Preset: See page 25 for more on how to save and recall station presets.
Step tuning: Use 4 and ¢ to step through the frequency band in either
direction.
Auto tuning: Press and hold 4 or ¢ until the frequency display starts to move
(about 1 second), then release. The tuner will stop on the next station it finds. Repeat to
search for other stations.
Hi-speed tuning: Press and hold 4 or ¢ until the frequency starts to change
at high speed (after about 4 seconds). Keep the button pressed until you reach the
frequency you want, then release. Use step tuning to fine-tune the station.
MONO
• The tuned indicator (
¢
• If the station is FM stereo, the stereo indicator (

Improving stereo FM sound

If you're listening to an FM station in stereo but the reception is weak, you can improve
the sound quality by switching to mono. Press
mono and auto stereo (if the broadcast is stereo, you'll hear it in stereo). The mono
indicator (

Listening to a connected component

If you connected another component, such as an MD player or turntable, to the
AUX IN
connected component. Press
select auxiliary. (The
but you'll have to take care of the connected component!)
/
FM AM TUNER
) shows the strength of the signal.
)lights when listening in mono.
jacks on the rear panel, just switch to auxiliary and start playback of your
(remote) or turn the
AUX
button (remote) will switch this unit on if it was in standby,
AUX
button to switch between the AM and FM bands.
dial to select either AM or FM
FUNCTION
) lights.
(remote only) to switch between
MONO
dial (front panel) to
FUNCTION