Advertisement
4.1
Adjustment of volume
(1) When replacing the "Lch board" or "Rch board", first, check if VR1 is in the "Medium" position as shown in the figure below.
(2) If VR1 is not in the "Medium" position, adjust it to "Medium".
VR1
Rch board and Lch board
5.1
Assembly precautions of power switch knob
When replacing the power switch knob, place the nonwoven fabric provided with the power switch knob over the slide switch
on the Rch board as shown in the picture, and then attach the housing.
Victor company of Japan, Limited
ACCESSORIES CATEGORY 1644, Shimotsuruma, Yamato, Kanagawa 242-8514, Japan
(No.XC063)
SECTION 4
ADJUSTMENT
SECTION 5
TROUBLESHOOTING
Rch board
Minimum
Maximum
Nonwoven fabric
(On the slide switch)
Medium
Printed in Japan
VPT
Advertisement
