Installing The Receiver; Opening The Front Panel - Pioneer Elite VSX-29TX Operating Instructions Manual

Remote Control Battery Alarm
When the batteries get too weak to operate the remote
control properly an alarm will sound and a warning
screen will appear on the remote. Change the batteries
as shown on the previous page.
Change Battery !!
SIZE AA, LR6 SIZE AA, LR6
The Touch Pen & Backlight
The touch pen is located in the back right-hand corner of
the remote control. Take it out by sliding your finger
along the bottom right edge of the remote control and
then grasping the pen with thumb and forefinger.
The backlight button is located in the top right-hand
corner on the back of the remote control. Use this button
in low-lighting to see the screen more clearly.
Back light switch
Touch pen
Remote Control Cushions
Apply the cushions to the feet of the remote control as
shown in the diagram below.
The area in which you can use the remote control to
operate the VSX-29TX is fairly large. To use, point the
remote control toward the remote sensor on the front
panel of this unit while within the range shown below.
OK ?
Please note:
• Do not place objects directly on top of this unit. This
• When installing in a rack, shelf, etc., be sure to leave
To open the front panel push gently on the lower third of
the panel with your finger.
Operating range of remote control unit
30
30
23 feet (7m)
Remote control may not function properly if:
memo
• There are obstacles between the remote
control and the remote sensor.
• Direct sunlight or fluorescent light is shining
onto the remote sensor.
• The receiver located near a device emitting
infrared rays.
• Operated simultaneously with another
remote control which uses infrared rays.

Installing the Receiver

would prevent proper heat dispersal.
more than 8 inches of space above the receiver.
8 inches (20 cm.)
Receiver

Opening the Front Panel

Before You Start
7