Table of Contents
Advertisement
Listening to other components
This system has several audio/video inputs for you to connect other components, such
as a VCR, MD deck, and so on. See chapter 12 for more on connecting up other
components.
1
Switch to the source you want to watch/listen to.
There are four external inputs you can connect components to. Select them using the
multi-control buttons:
• V-1 (Video 1)
• V-2 (Video 2)
• A-1 (Audio 1)
• A-2 (Audio 2)
Alternatively, you can use the
on the remote.
FUNCTION
2
Start playing the source component.
Switching between digital and analog sources
Both digital and analog inputs are available when Audio 1 or Video 2 is selected as the
source. The Input Select setting tells the system which input it should use.
See page 54 for more on connecting other components to this system.
Note: This system can only play Dolby Digital, PCM (32, 44.1, and 48kHz) and DTS
digital audio formats. For digital sources using other formats, use analog connections
and select
INPUT ANALOG
1
Press AUDIO A-1 or VIDEO V-2 (for the input you want to set).
The settings for the Audio 1 and Video 2 inputs are completely independent.
2
Press SYS then SETUP.
Press the @ or # button until you see INPUT in the display.
3
Use the % and fi buttons to select the input to use.
4
•
– the optical digital input is used as the source
INPUT OPTICAL
•
– the coaxial digital input is used as the source (this setting is
INPUT COAXIAL
only available for VIDEO 2)
•
– (default setting) the analog inputs are used as the source
INPUT ANALOG
5
Press ENTER to make the setting.
3 Getting Started
button on the front panel, or press
FUNCTION
.
then
SYS
19
En
Advertisement
Table of Contents
