STEP 1: Attach the high pres sure
hose to the spray gun by threading
twist connect onto spray gun inlet.
STEP 4: Connect the high pres sure
hose to the pump discharge ﬁ tting.
Thread twist connect to discharge
ﬁ tting by turning clockwise.
Due to Federal Reg u la tions con cern ing ship ment of cor ro sive chem i cals,
batteries are not shipped with this ma chine.
Local purchase of battery will be the responsibility of the owner. Au to mo tive
type 12 Volt Group 24 bat tery is rec om mend ed for place ment with in the
weath er re sis tant box. Fol low safe ty and in stal la tion in struc tions fur nished
with the bat tery.
Red Ca ble is at tached to bat tery (+) pos i tive ter mi nal, black cable is
Black - Negative
Red + Positive
STEP 2: Remove wand end and ﬁ rst
place the o-ring followed by the high
pressure nozzle as shown. Replace
end of wand.
STEP 5: Connect garden hose to
the cold water source.
con nect ed to bat tery (-) neg a tive
STEP 3: Remove shipping cap
and install oil dipstick (Depending
on type of shipping, dipstick may
already be installed). Check pump
oil lev el by us ing dip stick or observe
oil level in oil win dow (if equipped).
Use 30 wt. non detergent oil.
STEP 6: Check inlet ﬁ lters, remove
debris, then connect the garden
hose to pump water inlet. CAU TION:
Do not run the pump with out wa-
ter or pump dam age will result.
BLINDNESS OR INJURY
KEEP OUT OF THE REACH OF CHILDREN. DO NOT TIP. KEEP VENT CAPS TIGHT AND LEVEL.