Speaker Setting; Surround Back Speaker Setting - Pioneer VSX-D514 Operating Instructions Manual

06 Setting up the receiver
5 Repeat steps 3 and 4 to adjust other
setup options.
6 When you're done, press ENTER to
exit.
• The setting display is automatically exited
after 3 minutes of inactivity.

Speaker setting

• VSX-D514 default setting: S (all speakers)
• VSX-D714/D814 default setting: FL-CS-SS
(If a subwoofer is detected when you turn
the receiver on, the default is FS-CS-SS.)
You must let the receiver know how many
speakers you have, and how big they are. The
size you choose (large or small) determines
how much bass is sent from the receiver to
the speakers.
In the display, F, C, and S refer to front, center,
and surround speakers respectively. Speaker
size is denoted as L for large speakers, S for
small speakers, and
is connected.
• If the cone size (diameter) of the speaker
is larger than 15 cm, set the speaker size
to L.
• If you're not using a subwoofer, we
recommend setting the front speakers to
L.
• Cycle through the available choices
using or
that matches your speaker setup.
46
En
(asterisk) if no speaker
and choose a configuration
One of the following configurations should
match your setup:
FS-CS-SS
FL-C -S
FL-C -SS
FL-C -SL
FL-CS-S
FL-CS-SS
FL-CS-SL

Surround back speaker setting

VSX-D714/D814 only
• Default setting: S (VSX-D814),
D714)
You must let the receiver know if surround
back speaker(s) have been connected, and
how big they are. The size you choose (large or
small) determines how much bass is sent
from the receiver to the speakers. If you have
connected a subwoofer to the surround back
terminals (VSX-D814 only), you should select
the surround back subwoofer setting (SB SW)
from the options. Choose
speaker is connected.
• Use or to select SB S, SB , SB SW
or SB L.
SB S
SB L
* VSX-D814 only
FS-CS-S
FS-C -SS
FS-C -S
FL-CL-SL
FL-CL-SS
FL-CL-S
(VSX-
(asterisk) if no
SB
SB SW*