EXCEL 100C INSTALLATION INSTRUCTIONS
Setting the Port Selector Switch
IMPORTANT
You must properly set the port selector (left to the front port, see figure on page 30); e.g. after having operated an MMI via the
front port, the switch must be set back to its left position to reactivate a modem being connected to the rear terminals. If the
switch is set to "front port", the rear terminals are deactivated, and vice versa.
Front port
active
REMOTE COMMUNICATIONS
EN1R-0144GE51 R1007
6.
Reattach the cover.
Rear terminals
active
For remote communications with up to three XBS Building Centrals, a modem or
ISDN* terminal adapter can be connected directly to the front serial port or the rear
terminals on the base of the Excel 100C (see graphics below).
NOTES: Remote communication via modem or ISDN* terminal adapter requires
firmware version V2.03.01 or higher.
XBSi building supervisors are not supported for remote communication.
30