Making Connections - Sony RSX-GS9 Operating Instructions Manual

E:\DATA\4577101111\4577101111RSXGS9UC\01GB-RSXGS9UC\040CD.fm
010COV.book Page 35 Thursday, July 2, 2015 2:07 PM
*1 Not supplied
*2 RCA pin cord (not supplied)
*3 Depending on the type of car, use an adaptor for a
wired remote control (not supplied).
*4 Whether in use or not, route the microphone input
cord such that it does not interfere with driving
operations. Secure the cord with a clamp, etc., if it is
installed around your feet.
*5 For details on installing the microphone, see
"Installing the microphone" (page 36).
*6 When the amperage rating of the fuse used on your
car is 10 A, make the power connection to the
battery directly to avoid short circuits.
*7 When making the optical connection, an optical
cable (not supplied) is required.
*8 To connect a smartphone to the main unit, an
appropriate cable (not supplied) is required.
*9 To connect an iPod/iPhone, use the USB connection
cable for iPod (not supplied).
*10For details on the connection, refer to "Guide to
Audio Device Connection" (page 7).
*11 To secure the connectors, wrap the hook and loop
fastener around the neck of connectors, then
bring the ends of the hook and loop fastener
together.

Making connections

To a common ground (earth) point
First connect the black ground (earth) lead, then
connect the yellow and red power supply leads.
To the +12 V power terminal which is
energized at all times
Be sure to first connect the black ground (earth)
lead to a common ground (earth) point.
To the +12 V power terminal which is
energized when the ignition switch is set to
the accessory position
If there is no accessory position, connect to the
+12 V power (battery) terminal which is
energized at all times.
Be sure to first connect the black ground (earth)
lead to a common ground (earth) point.
To the power antenna (aerial) control lead or
the power supply lead of the antenna (aerial)
booster
It is not necessary to connect this lead if there is
no power antenna (aerial) or antenna (aerial)
booster, or with a manually-operated telescopic
antenna (aerial).
To AMP REMOTE IN of an optional power
amplifier
This connection is only for amplifiers and a
power antenna (aerial). Connecting any other
system may damage the unit.
To a car's illumination signal
Be sure to first connect the black ground (earth)
lead to a common ground (earth) point.
When making the high level input
connection
For details, see "High level input connection"
(page 36).
To the left speaker output (white) of an audio
device
To the right speaker output (gray) of an audio
device
When connecting to the battery directly
When the amperage rating of the fuse used on your
car is 10 A, make the power connection to the
battery directly to avoid short circuits.
to a metal point of car
to the positive battery terminal
Notes
Despite connecting to the power supply lead of the
car, the unit may not fully provide its performance
due to insufficient power. In this case, make the
power connection to the battery directly.
Make sure that the car's battery wires connected to
the car (ground (earth) to chassis) are of a wire gauge
at least equal to that of the main power wire
connected from the battery to the head unit.
If you have any questions or problems concerning
the connection, consult the dealer for details.
Recommended High-Resolution USB
Audio system
Power amplifier
(e.g. XM-GS4)
RSX-GS9
(this unit)
Power amplifier
(e.g. XM-GS100)
Note
Certain products shown in the diagram may not be
available in your country or region.
masterpage: Right
Super tweeter
(e.g. XS-GS1)
Full-range speaker
(e.g. XS-GS1621)
Subwoofer
(e.g. XS-GSW121)
35
GB
RSX-GS9
4-577-101-11(1)