Additional information
12
Message
PQLS OFF
PQLS ON
UNKNOWN
Note
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operating conditions.
Resetting the main unit
Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
1
Switch the receiver into standby.
2
While holding down the TONE button, press and
hold the
STANDBY/ON button for about three
seconds.
3
When you see RESET? appear in the display,
press ENTER.
OK? shows in the display.
4
Press SYSTEM SETUP to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
80
En
Explanation
This is displayed on a playback component when PQLS turns off during playback. The sound may be
interrupted momentarily when this happens.
This is displayed on a playback component when PQLS turns on during playback. The sound may be
interrupted momentarily when this happens.
When an i.LINK-equipped component name cannot be recognized, this message is displayed instead of
the proper component name.
Switching the speaker impedance
We recommend using speakers of 8Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6Ω impedance rating.
•
With the receiver in standby, press
ON while holding down the SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your speakers are
rated at 6Ω.
• SP 8 OHM – Use this setting if your speakers are
rated at 8Ω or more.
STANDBY/