Crossover Network; Channel Level - Pioneer PDK-1014 Operating Instructions Manual

The System Setup menu

Crossover Network

• Default setting: 80Hz
This setting decides the cutoff between bass sounds
playing back from the speakers selected as LARGE, or
the subwoofer, and bass sounds playing back from those
selected as SMALL. It also decides where the cutoff will
be for bass sounds in the LFE channel.
Note
• For more on selecting the speaker sizes, see Speaker
Setting above.
1 Select 'Crossover Network' from the Manual SP
Setup menu.
4. Manual SP Setup
[ a . Speaker Setting
[ b . Crossover Network
[ c . Channel Level
[ d . Speaker Distance
2 Choose the frequency cutoff point.
Frequencies below the cutoff point will be sent to the
subwoofer (or LARGE speakers).
4b. Crossover Network
Frequency
(THX Speaker = 80Hz)
3 When you're finished, press RETURN.
You will return to the Manual SP Setup menu.
Note
• If you're using a THX speaker setup, confirm that the
crossover frequency is set to 80Hz.
]
]
]
]
[ 80Hz ]

Channel Level

Using the channel level settings, you can adjust the
overall balance of your speaker system, an important
factor when setting up a home theater system.
1 Select 'Channel Level' from the Manual SP Setup
menu.
4. Manual SP Setup
[ a . Speaker Setting
[ b . Crossover Network
[ c . Channel Level
[ d . Speaker Distance
2 Select a setup option.
4c. Channel Level
Test Tone [ [ Auto ] ]
Enter : Next
Return : Cancel
• Manual – Move the test tone manually from speaker
to speaker and adjust individual channel levels.
• Auto – Adjust channel levels as the test tone moves
from speaker to speaker automatically.
3 Confirm your selected setup option.
The test tones will start after you press ENTER.
4c. Channel Level
Test Tone
Setting Start
Please Wait
Caution!!
Test tone is
output loudly.
Return:Cancel
4 Adjust the level of each channel using the
(cursor left/right) buttons.
If you selected Manual, use
switch speakers. The Auto setup will output test tones in
the order shown on-screen:
4c. Channel Level
Left
Center
Right
Surround R
Surr Back R
Surr Back L
Surround L
Sub Woofer
Adjust the level of each speaker as the test tone is
emitted.
]
]
]
]
4c. Channel Level
Test Tone [ Manual ]
Enter : Next
Return : Cancel
[ Manual ]
(cursor up/down) to
[ + 0.5dB]
[ 0.0dB]
[ 0.0dB]
[ 0.0dB]
[ 0.0dB]
[ 0.0dB]
[ 0.0dB]
[ 0.0dB]
Return:Finish
06
45
En