Operating Range Of Remote Control Unit - Pioneer PDK-1014 Operating Instructions Manual

Controls and displays
11 SOURCE
Press to turn on/off other components connected to the
receiver (see page 53 for more on this).
12 Character display (LCD)
This display shows information when transmitting
control signals.
The following commands are shown when you're setting
the remote to control other components (see Controlling
the rest of your system on page 53):
SETUP
Indicates the setup mode, from which you choose the
options below.
PRESET
See Selecting preset codes directly on page 53.
LEARN
See Programming signals from other remote controls
on page 54.
DIRECT F
See Direct function on page 55.
ERASE
See Erasing one of the remote control button settings
on page 55.
RESET
See Erasing all of the remote control presets on
page 55.
READ ID
See Confirming preset codes on page 55.
13 RECEIVER
Switches the remote to control the receiver (used to
select the green commands above the number buttons
(INPUT ATT, etc). Also use this button to set up surround
sound (page 11, page 38).
14 VOL +/–
Use to set the listening volume.
15 MUTE
Mutes the sound or restores the sound if it has been
muted (adjusting the volume also restores the sound).

Operating range of remote control unit

The remote control may not work properly if:
• There are obstacles between the remote control and
the receiver's remote sensor.
• Direct sunlight or fluorescent light is shining onto the
remote sensor.
• The receiver is located near a device that is emitting
infrared rays.
• The receiver is operated simultaneously with another
infrared remote control unit.
30
30
7m
04
29
En