Example Of Installation On The Floor Mat Or On The Chassis; Replacing The Terminal Cover - Pioneer PRS-D400 Owner's Manual

Example of installation on the
floor mat or on the chassis
1. Place the amplifier where it is to be
installed. Insert the supplied tap-
ping screws (4 × 18 mm) into the
screw holes. Push on the screws
with a screwdriver so they make
marks where the installation holes
are to be located.
2. Drill 2.5 mm diameter holes at the
point marked, and install the ampli-
fier, either on the carpet or directly
to the chassis.

Replacing the terminal cover

1. Align the unit and terminal cover,
and insert the screw.
2. Tighten the screw with a 4 mm
hexagonal wrench (not supplied).
Screw
Drill a 2.5 mm diameter hole
Tapping-screws
(4 × 18 mm)
Terminal Cover
Floor mat
or chassis
12 12