Pioneer GM-3100T Owner's Manual

Pioneer GM-3100T Owner's Manual

Bridgeable two-channel power amplifier
Hide thumbs Also See for GM-3100T:
Table of Contents

Advertisement

Available languages

Available languages

BRIDGEABLE TWO-CHANNEL
POWER AMPLIFIER
AMPLIFICATEUR DE PUISSANCE
PONTABLE A DEUX VOIES
Owner's Manual
GM-3100T
Mode d'emploi
PIONEER CORPORATION
4-1, MEGURO 1-CHOME, MEGURO-KU, TOKYO 153-8654, JAPAN
PIONEER ELECTRONICS (USA) INC.
P.O. Box 1540, Long Beach, California 90801-1540, U.S.A.
TEL: (800) 421-1404
PIONEER EUROPE NV
Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium
TEL: (0) 3/570.05.11
PIONEER ELECTRONICS ASIACENTRE PTE. LTD.
253 Alexandra Road, #04-01, Singapore 159936
TEL: 65-6472-7555
PIONEER ELECTRONICS AUSTRALIA PTY. LTD.
178-184 Boundary Road, Braeside, Victoria 3195, Australia
TEL: (03) 9586-6300
Published by Pioneer Corporation.
Copyright © 2004 by Pioneer Corporation.
PIONEER ELECTRONICS OF CANADA, INC.
All rights reserved.
300 Allstate Parkway, Markham, Ontario L3R OP2, Canada
TEL: 1-877-283-5901
Publication de Pioneer Corporation.
Copyright © 2004 Pioneer Corporation.
PIONEER ELECTRONICS DE MEXICO, S.A. de C.V.
Tous droits de reproduction et de traduction
Blvd.Manuel Avila Camacho 138 10 piso
réservés.
Col.Lomas de Chapultepec, Mexico, D.F. 11000
TEL: 55-9178-4270
Printed in China
Imprimé en Chine
<KMINX> <04I00000>
<CRD3926-A/U> UC
Before Using This Product
Thank you for purchasing this PIONEER
After-sales service for Pioneer
product. It is designed to give you many
products
years of enjoyment.
PIONEER SUGGESTS USING A PRO-
FESSIONAL INSTALLER DUE TO THE
Please contact the dealer or distributor from where
COMPLEXITY OF THIS PRODUCT.
you purchased the product for its after-sales ser-
Please read all instructions and WARN-
vice (including warranty conditions) or any other
information. In case the necessary information is
INGS in this manual before attempting
not available, please contact the companies listed
operation. Should you have any questions,
below:
contact your nearest Pioneer authorized
Please do not ship your product to the companies
dealer or installation specialist.
at the addresses listed below for repair without
advance contact.
Information to User
7 U.S.A.
Alteration or modifications carried out
Pioneer Electronics (USA) Inc.
without appropriate authorization may
CUSTOMER SUPPORT DIVISION
invalidate the user's right to operate the
P.O. Box 1760
equipment.
Long Beach, CA 90801-1760
800-421-1404
Important
7 CANADA
The serial number of this amplifier is writ-
Pioneer Electronics of Canada, Inc.
ten on the bottom of the unit. For your
CUSTOMER SATISFACTION
own security and convenience, write it
DEPARTMENT
down on the enclosed warranty card. Keep
300 Allstate Parkway
the card handy for future reference.
Markham, Ontario L3R OP2
1-877-283-5901
For warranty information please see the Limited
Warranty sheet included with your product.
Product registration
Visit us at the following site:
1 Register your product. We will keep the details of
your purchase on file to help you refer to this
information in the event of an insurance claim
such as loss or theft.
2 Receive updates on the latest products and tech-
nologies.
3 Download owner's manuals, order product cata-
logues, research new products, and much more.
<ENGLISH>
WARNING
CAUTION
• Handling the cord on this product or cords associ-
Never replace the fuse with one of greater
ated with accessories sold with the product will
value or rating than the original fuse. Use
expose you to lead, a chemical known to the State
of an improper fuse could result in over-
of California and other governmental entities to
cause cancer and birth defects or other reproduc-
heating and smoke and could cause dam-
tive harm. Wash hands after handling.
age to the product and injury including
• Always use the special red battery and ground
burns.
wire [RD-223], which is sold separately. Connect
the battery wire directly to the car battery positive
terminal (+) and the ground wire to the car body.
CAUTION
• Do not touch the amplifier with wet hands.
Otherwise you may get an electric shock. Also, do
Diagram A - Proper
Diagram B - Improper
not touch the amplifier when it is wet.
• For traffic safety and to maintain safe driving
8
4
conditions, keep the volume low enough so that
+
-
+
-
you can still hear normal traffic sound.
Ohm
Ohm
Speaker
Speaker
• Check the connections of the power supply and
speakers if the fuse of the separately sold battery
8
4
wire or the amplifier fuse blows. Detect the cause
+
-
+
-
Ohm
Ohm
and solve the problem, then replace the fuse with
Speaker
Speaker
another one of the same size and rating.
L+
R-
L+
R-
• To prevent malfunction of the amplifier and
speakers, the protective circuit will cut the power
Pioneer
Pioneer
Amplifier
Amplifier
supply to the amplifier (sound will stop) when an
abnormal condition occurs. In such a case, switch
4 Ohm Bridged Mode
2 Ohm Bridged Mode
the power to the system OFF and check the
connection of the power supply and speakers.
Do NOT install or use your Pioneer ampli-
Detect the cause and solve the problem.
fier by wiring speakers rated at 4 Ohm (or
• Contact the dealer if you cannot detect the cause.
lower) in parallel to achieve a 2 Ohm (or
• To prevent an electric shock or short-circuit
lower) bridged mode (Diagram B).
during connection and installation, be sure to
Amplifier damage, smoke, and overheating
disconnect the negative (–) terminal of the battery
could result from improper bridging. The
beforehand.
amplifier surface could also become hot to
• Confirm that no parts are behind the panel when
the touch and minor burns could result.
drilling a hole for installation of the amplifier. Be
sure to protect all cables and important equipment
To properly install or use a bridged mode
such as fuel lines, brake lines and the electrical
for a two-channel amplifier and achieve a 4
Ω load, wire two 8 Ω speakers in parallel
wiring from damage.
• DO NOT allow amplifier to come into contact
with Left + and Right - (Diagram A) or use
with liquids due to, for example, the location
a single 4 Ω speaker. For a four-channel
where the amplifier is installed. Electrical shock
amplifier, follow the speaker output con-
could result. Also, amplifier and speaker damage,
nection diagram for bridging as shown on
smoke, and overheating could result from contact
the back of your amplifier, and wire two 8
with liquids. In addition, the amplifier surface and
Ω speakers in parallel to achieve a 4 Ω
the surface of any attached speakers could become
load or use a single 4 Ω speaker per chan-
hot to the touch and minor burns could result.
nel.
If you have any questions or concerns,
please contact your local authorized
Pioneer dealer or call Pioneer customer
service.

Advertisement

Table of Contents
loading

Summary of Contents for Pioneer GM-3100T

  • Page 1 4 Ohm Bridged Mode Markham, Ontario L3R OP2 1-877-283-5901 Do NOT install or use your Pioneer ampli- For warranty information please see the Limited fier by wiring speakers rated at 4 Ohm (or Warranty sheet included with your product.
  • Page 2: Setting The Unit

    (standard output of 500 mV), set to body. the NORMAL position. When using with an RCA equipped Pioneer car stereo with max. output of 4 V or more, adjust level to match the car stereo output level. • If you hear too much noise when using the speaker input terminals, turn the gain control counter-clockwise.
  • Page 3: Installation

    Connecting the Unit <ENGLISH> Installation Using the Speaker Input Connecting the Speaker Wires Connect the car stereo speaker output The speaker output mode can be two-chan- • Do not install in: wires to the amplifier using the supplied nel (stereo) or one-channel (mono). speaker input connector.
  • Page 4: Avant D'utiliser Cet Appareil

    Avant d’utiliser cet appareil Nous vous remercions d’avoir porté votre Service après-vente pour un choix sur un appareil PIONEER. Il a été PRÉCAUTION produit Pioneer conçu et fabriqué pour vous apporter de nombreuses années de satisfaction. Ne remplacez pas le fusible par un fusible En raison des problèmes posés par...
  • Page 5: Raccordement De L'appareil

    Raccordement de l’appareil Schéma de raccordement PRÉCAUTION • Pour éviter tout risque de court-circuit ou • Veillez à ce qu’aucun câble ne soit en court- d’endommager cet appareil, débranchez le câble circuit, faute de quoi le circuit de protection Passe-câble relié...
  • Page 6 75 W × 2 (pour 14,4 V, 2 Ω, 20 Hz — 20 kHz, avec une DHT de 0,8%) tiones, póngase en contacto con su Impédance de charge ... 4 Ω (2 — 8 Ω permis) revendedor autorizado de Pioneer o con un (Montage ponté: 4 — 8 Ω permis) especialista de instalación más próximo.
  • Page 7: Ajuste De Esta Unidad

    500 mV), ajuste a la posición NORMAL. deslizamiento de los asientos. Cuando use con un estéreo de automóvil Pioneer equipado con RCA con una salida máxima de 4 V o más, ajuste el nivel para adecuarse al nivel de salida del estéreo del automóvil.
  • Page 8: Instalación

    Conexión de la unidad <ESPAÑOL> Instalación Uso de la entrada de altavoz Conexión de los cables de PRECAUCION altavoces Conecte los hilos de la salida de altavoz • No lo instale en: del estéreo de automóvil al amplificador —Donde podría lesionar al conductor o a los El modo de salida de altavoces puede ser usando el conector de entrada de altavoz en dos canales (estéreo) o uno canal...

Table of Contents