Loading Batteries - Pioneer A-35R Elite Operating Instructions Manual

CONNECTIONS
CONNECTING THE INPUT/OUTPUT
CORDS
Connect the white plug to the L (left) channel, and the red plug
to the R (right) channel. Be sure to push the plugs securely.
Left channel
White plug
R
REMOTE CONTROL CORD CONNEC-
TIONS
By interconnecting the CONTROL jacks of Pioneer units with
the Î mark, the entire system can be operated with this
remote control unit, although some of the units (AM/FM
tuner, CD player, cassette deck, etc.) may not be equipped
with remote sensors. The entire system can be operated by
a remote control unit by connecting PIONEER stereo compo-
nents to each other using the control input (CONTROL IN) jack
on each component. Use the remote control cord supplied
with the respective unit for the connection. An example is
shown in the figure. As long as you connect "OUT" to "IN",
the connecting sequence is arbitrary. When a unit has only an
"IN" connector, however, connect it last.
NOTE:
When the POWER switch is set to OFF, the components
connected to the CONTROL OUT jack can not be operated
with the remote control unit.
AM/FM
CD player
tuner
CONTROL
CONTROL
OUT IN OUT IN
6
<ARE7263>
En
L
Right channel
Red plug
Remote
control unit
A-35R
Cassette
deck
CONTROL
OUT
CONTROL
OUT IN

LOADING BATTERIES

Open the battery compartment cover on the back of the
remote control unit.
Insert size AA/R6P dry cell batteries into the battery compart-
ment in accordance with the indications (ª ,·) inside the
compartment.
Close the cover of the battery case.
Incorrect use of batteries may lead to leakage or
rupture. Always be sure to follow these guidelines:
1. Always insert batteries into the battery compartment cor-
rectly matching the positive ª and the negative · polari-
ties as indicated inside the compartment.
2. Never mix new and used batteries.
3. Batteries of the same size may have different voltages
depending on their type. Do not mix different types of
batteries.
RANGE OF REMOTE CONTROL
When the remote control unit is pointed at the remote sensor
window on the stereo amplifier and any of its buttons is
pressed, the unit and other components can be operated by
remote control.
Distance : Within a range of approx. 7 meters from the unit's
remote control sensor window.
Angle : Within approx. 30 degrees from the center of the
unit's remote control sensor window.
Remote control will not be possible if there is an
obstacle between the remote control unit itself
and the unit's remote control sensor window.
÷ The accessory remote control unit can be used to control
some functions of other Pioneer cassette decks, CD play-
ers and tuners (only those Pioneer components bearing
the Î mark).
Remote control
sensor window
30
30
·
ª
ª
·
7 m