Table of Contents
Advertisement
(5) Paste spacer A (BMR1073) to the top board of the
multi-projection unit and spacers B (BMR1074) to the
1 2 3 4
1 2 3 4
two sides at the
position shown in the figure after
1 2 3 4
peeling off the seal.
(6) Insert the multi-projection unit from the rear of the
unit in this state.
* Paste after adjusting the
center of the top board
to that of spacer A.
* Paste without cover-
ing the fan.
Unit
INSTALLATION AND ASSEMBLY
(7) Attach the attachments R and L to the unit through the
top board of the unit using the screws (M6
then attach attachments R and L to the unit from the
back using screws (M6
20). (2 screws
*Drop the screw-lock fluid to screws so as not to loosen.
(4 points)
(8) Check the Focus and reajust if necessary.
(9) Attach the cover (BNE1012) to the top board of the unit
using the four screws (M5
20) and
2 locations).
15).
Screw (M5
15)
51
Advertisement
Table of Contents
