Table of Contents
Advertisement
Available languages
Available languages
Connections
Important
! This unit can not be installed in a vehicle that
does not have an ACC (accessory) position on
the ignition switch.
ACC posi-
No ACC po-
tion
sition
! Use this unit in other than the following condi-
tions could result in fire or malfunction.
— Vehicles with a 12-volt battery and negative
grounding.
! To prevent short-circuit, overheating or mal-
function, be sure to follow the directions
below.
— Disconnect the negative terminal of the
battery before installation.
— Secure the wiring with cable clamps or ad-
hesive tape. To protect the wiring, wrap ad-
hesive tape around them where they lie
against metal parts.
— Place all cables away from moving parts,
such as gear shift and seat rails.
— Place all cables away from hot places,
such as near the heater outlet.
— Do not pass the yellow cable through a
hole into the engine compartment to con-
nect to a battery.
— Cover any disconnected cable connectors
with insulating tape.
— Do not shorten any cables.
— Never cut the insulation of the power cable
of this unit in order to share the power to
other equipment. Current capacity of the
cable is limited.
— Use a fuse of the rating prescribed.
! Refer to the owner’s manual for details on
connecting the power amp and other units,
then make connections correctly.
! IP-BUS connectors are color-coded. Be sure
to connect connectors of the same color.
Section
06
Cord function may differ according to the pro-
duct, even if cord color is the same. When con-
necting this system, be sure to check all
manuals and connect cords correctly.
Page 35
En
Advertisement
Chapters
Table of Contents
