2-5. SERVICE POSITION
• REMOVAL OF ANODE-CAP
Short circuit the anode of the picture tube
and the anode cap to the metal chassis, CRT shield
or carbon paint on the CRT, after removing the
• REMOVING PROCEDURES
Turn up one side of the rubber cap in the direction indicated
by the arrow®.
Using a thumb pull up the rubber cap firmly in the direction
indicated by the arrow®.
When one side of the rubber cap is separated from the anode
button, the anode-cap can be removed by turning up the
rubber cap and pulling up it in the direction of the arrow
• HOW TO HANDLE AN ANODE.CAP
Don't hurt the surface of anode-caps with sharp shaped
Don't press the rubber hardly not to hurt insilie of anode-
caps! A material fitting called as shatter-hook terminal is
built in the rubber.
Don't turn the foot of rubber over hardly! The shatter-hook
terminal will stick out or hurt the rubber.