Using On-Screen Menus
[gj]NTSC SETUP LEVEL
Select the NTSC setup level from two modes.
The 7.5 setup level is mainly used in nonh America.
The 0 setup level is mainly used in Europe.
For PVM-14M4U/ 14M2U/20M4U/20M2U
Set ACC (Auto Color Control) circuit on or off. When
the fine adjustment is necessary, select OFF on the
Normally select ON.
You can select the menu language from among five
languages (English, German, French, Italian, Spanish).
This menu is provided only for PVM-20M4U/20M4E.
If the color is not uniform even after you press the
DEGAUSS button, you can adjust the landing so as to
obtain color uniformity on this screen.
The following two methods are available to adjust the
When the signals of the horizontal lines are input
Press the·/- or
button until the lines are
displayed on the screen as horizontally as possible.
When the signals of the white color are input and
Press the ·/-or
button until the white color on
the screen become as uniform as possible.
To reset the setting to standard (00), press the
. . . . · ..
Connect the AC power cord (supplied) to the AC IN
socket and to a wall outlet.
To connect an AC power cord securely
with an AC plug holder
AC IN socket
AC plug holder
Plug the power cord into the AC IN socket. Then, auach
the AC plug holder (supplied) un top of the AC power
Slide the A.C plug holder over the cord until it locks.
To remove the AC power cord
Pull out the AC plug holder while pressing the lock
Connect a coaxial cable with the BNC plugs to the
BNC connectors on the rear panel as illustrated below.
Insert the BNC plug into the
connector on the rear panel,
matching the slit and pin,
the BNC plug clockwise