General; Location Of Controls; Connections - Sony CDX-GT700D Service Manual

• LOCATION OF CONTROLS

• CDX-GT700D (AEP, UK Model)
Location of controls and basic operations
Main unit
1 234 5 6
OFF
GP/ALBM
PUSH SOUND
MENU
SEEK– SEEK+
ENTER
DSPL/
PTY
GP/ALBM MODE
SOURCE
qa qs qd qf
Front panel removed
qk
RESET
Card remote commander
RM-X154
wd
2
OFF ATT
wf
qd
SOURCE SOUND MODE
qf
6
MENU LIST
wg
+
qs
wh
ENTER
wa
–
wj
qa DSPL/PTY SCRL
REP SHUF
1 2 3
qg
PAUSE
4 5 6
+
ws
VOL
–
6

• CONNECTIONS

• CDX-GT700D (AEP, UK Model)
A
SUB OUT (MONO)
AUDIO OUT
REAR
B
BUS AUDIO IN
BUS CONTROL IN
Source selector*
Signalquellenwähler*
Sélecteur de source*
Selettore di fonte*
Geluidsbronkiezer*
XA-C30
SECTION 1

GENERAL

7 8 9 q;
OPEN
BBE
BBE MP
IMAGE
HDEQ
REP SHUF PAUSE
AF/TA
1 2 3 4 5 6
CDX-GT700D
qg qh qj
ql w;
Refer to the pages listed for details. The
corresponding buttons on the card remote
commander control the same functions as those
on the unit.
A SEEK –/+ buttons
CD:
To skip tracks (press); skip tracks
continuously (press, then press again within
about 1 second and hold); fast-forward/
reverse a track (press and hold).
Radio:
To tune in stations automatically (press); find
a station manually (press and hold).
B OFF button
To power off/stop the source.
C Receptor
To receive signals from the card remote
commander.
D VOL (volume) control dial/SOUND
button 16
To adjust volume (rotate); select sound items
(press).
AUDIO OUT
FRONT
BUS AUDIO IN
BUS CONTROL IN
* not supplied
nicht mitgeliefert
non fourni
non in dotazione
niet bijgeleverd
CDX-GT700D/GT705DX
E GP*
1 /ALBM* 2 +/– buttons* 3
To select preset stations/skip groups (press);
skip groups continuously (press and hold).
F MENU button
To enter menu.
G Display window
H BBE MP button 2, 12, 13
To activate the BBE MP function.
I OPEN button 5
J IMAGE button 2
To select the display image.
Movie mode 1-3 t Spectrum analyzer
mode 1-5 t Space Producer mode t Wall
paper mode 1-3 t normal play/reception
mode
K DSPL (display)/PTY (Programme
Type) button 8, 10
To change display items; to select PTY in
RDS.
L ENTER button
To complete a setting.
M SOURCE button
To power on/change the source (Radio/CD/
MD* 5 /AUX).
N MODE button 8, 17
To select the radio band (FM/MW/LW)/
select the unit* 4 .
O Number buttons
Radio:
To receive stored stations (press); store
stations (press and hold).
CD/MD* 5 :
(1): REP 8, 18
(2): SHUF 8, 18
(6): PAUSE* 6
To pause playback. To cancel, press again.
P AF (Alternative Frequencies)/TA
(Traffic Announcement) button 10
To set AF and TA/TP in RDS.
Q HDEQ button 11, 12
To select an equalizer type (Flat, Xplod,
Refined Vocal, Over Drive, Virtual Sub,
Natural Cruise or Rear Drive)
R RESET button 4
S Z (eject) button 5
To eject the disc.
Connection example
Notes (2- A )
• Be sure to connect the earth lead before connecting the
amplifi er.
• The alarm will only sound if the built-in amplifi er is used.
Tip (2- B - )
For connecting two or more CD/MD changers, the source
selector XA-C30 (not supplied) is necessary.
Anschlussbeispiel
Hinweise (2- A )
• Schließen Sie unbedingt zuerst das Massekabel an, bevor Sie
den Verstärker anschließen.
• Der Signalton wird nur ausgegeben, wenn der integrierte
Verstärker verwendet wird.
Tipp (2- B - )
Zum Anschließen von zwei oder mehr CD/MD-Wechslern wird
der Signalquellenwähler Cuight mitgeliefert (night mitgeliefert)
XA-C30 benötigt.
Exemple de raccordement
Remarques (2- A )
• Raccordez d'abord le câble de mise à la masse avant de
connecter l'amplifi cateur.
• Un bip est émis uniquement lorsque l'amplifi cateur intégré est
utilisé.
Conseil (2- B - )
Dans le cas du raccordement de deux changeurs de CD/MD
ou plus, le sélecteur de source XA-C30 (non fourni) est
indispensable.
Esempio di collegamento
Note (2- A )
• Assicurarsi di collegare il cavo di terra prima di collegare
l'amplifi catore.
• Il segnale acustico viene emesso solo se viene utilizzato
l'amplifi catore incorporato.
Suggerimento (2- B - )
Per collegare due o più cambia CD/MD, si deve utilizzare il
selettore di fonte XA-C30 (non in dotazione).
Voorbeeldaansluitingen
Opmerkingen (2- A )
• Sluit eerst de aarddraad aan voordat u de versterker aansluit.
• U hoort de pieptoon alleen als de ingebouwde versterker wordt
gebruikt.
Tip (2- B - )
Om twee of meer CD/MD-wisselaars aan te sluiten, hebt u de
geluidsbronkiezer XA-C30 (niet bijgeleverd) nodig.
This section is extracted
from instruction manual.
T Disc slot 5
To insert the disc.
The following buttons on the card remote
commander have also different buttons/functions
from the unit.
wa </, (SEEK –/+) buttons
To control CD/Radio, the same as (SEEK)
–/+ on the unit.
ws VOL (volume) +/– button
To adjust volume.
wd ATT (attenuate) button
To attenuate the sound. To cancel, press
again.
wf SOUND button
To select sound items.
wg LIST button 9, 18
To list up.
wh M/m (+/–) buttons
To control CD, the same as (GP/ALBM) +/–
on the unit.
wj SCRL (scroll) button 8
To scroll the display item.
*1 When an ATRAC CD is played.
*2 When an MP3/WMA is played.
*3 If the changer is connected, the operation is
different, see page 17.
*4 When a CD/MD changer is connected.
*5 When an MD changer is connected.
*6 When playing back on this unit.
Note
If the unit is turned off and the display disappears, it
cannot be operated with the card remote commander
unless (SOURCE) on the unit is pressed, or a disc is
inserted to activate the unit first.
Tip
For details on how to replace the battery, see
"Replacing the lithium battery of the card remote
commander" on page 21.
7
5