Download  Print this page

Mechanical Adjustments; Electrical Adjustments; Test Mode; Tape Deck Section - Sony XR-C5080R Service Manual

Fm/mw/lw cassette car stereo.
Hide thumbs

Advertisement

SECTION 4

MECHANICAL ADJUSTMENTS

1. Clean the following parts with a denatured-alcohol-moistened
swab:
playback head
pinch roller
rubber belt
capstan
idler
2. Demagnetize the playback head with a head demagnetizer.
3. Do not use a magnetized screwdriver for the adjustments.
4. After the adjustments, apply suitable locking compound to the
parts adjusted.
5. The adjustments should be performed with the power supply
voltage unless otherwise noted.
• Torque Measurement
Mode
Torque Meter
Forward
CQ-102C
Forward
CQ-102C
Back Tension
Reverse
CQ-102RC
Reverse
CQ-102RC
Back Tension
FF, REW
CQ-201B
• Tape Tension Measurement
Mode
Tension Meter
Forward
CQ-403A
Reverse
CQ-403R
Meter Reading
30 - 65 g•cm
(0.42 - 0.90 oz•inch)
0.5 - 4.5g•cm
(0.01 - 0.06 oz•inch)
30 - 65 g•cm
(0.42 - 0.90 oz•inch)
0.5 - 4.5g•cm
(0.01 - 0.06 oz•inch)
60 - 200 g•cm
(0.83 - 2.78 oz•inch)
Meter Reading
more than 90 g
(more than 3.18 oz)
more than 90 g
(more than 3.18 oz)
– 14 –
SECTION 5

ELECTRICAL ADJUSTMENTS

TEST MODE

This set have the test mode function. In the test mode, FM Auto
Scan/Stop Level and AM (MW) Auto Scan/Stop Level adjustments
can be performed easier than it in ordinary procedure.
<Set the Test Mode>
1. Set the "power select" switch (S801) is "A" position.
2. Turn ON the regulated power supply. (All LEDs on the set
lights up, and the clock is displayed.)
[OFF]
Note: Press the
button, if the clock is not displayed.
[4]
3. Push the preset
button.
[5]
4. Push the preset
button.
[1]
5. Press the preset
button for more than two seconds.
6. Then the display indicates all lights, the test mode is set.
<Release the Test mode>
1. Push the [OFF] button.
2. Return the "power select" switch (S801) to initially set posi-
tion.
See the adjustment location from on page 17 for the
adjustment.

TAPE DECK SECTION

Tape Speed Adjustment
Setting:
test tape
WS-48A
(3 kHz, 0 dB)
set
speaker out terminal
Procedure:
1. Put the set into the FWD PB mode.
2. Adjust adjustment resistor for inside capstan motor so that the
reading on the speed checker or frequency counter becomes in
specification.
Specification: Constant speed
Speed checker
–1.5 to +2.5%
Adjustment Location: See page 17.
0 dB=0.775 V
speed checker
or
frequency counter
4 Ω
+
Frequency counter
2,955 to 3,075Hz

Advertisement

Table of Contents

   Also See for Sony XR-C5080R

   Related Manuals for Sony XR-C5080R

This manual is also suitable for:

Xr-c5090r

Comments to this Manuals

Symbols: 0
Latest comments: