Advertisement
respectively connected JY-61 module :VCC，RX，TX，GND。Note TXD and RXD should be
crossover。
(Notice： The switch of Six serial interface module needs to be configed as the following figure
when connecting to 6050 module)
4.2 Installation USB-TTL module driver
First, the module is connected via USB-TTL module to the computer, install the USB-TTL
module driver.
After installing the USB-TTL module driver, and then Device Manager can query
corresponding serial number, as below figure shows:
http://www.aliexpress.com/store/1836321
- 3 -
Advertisement
