Preventing The Plasma Television From Falling Over - Pioneer PDP-507XD Operating Instructions Manual

Preparation
05
(PDP-507XD)
NOTE
• Do not hold by the side speaker.
Preventing the Plasma Television from
Falling Over
After installing the stand, be sure to take special care to ensure
that the Plasma Television will not fall over.
Stabilizing on a table or floor
Stabilize the Plasma Television as shown in the diagram using
screws that are available on the market.
NOTE
To stabilize the Plasma Television on a table or on the floor, use
screws that have a nominal diameter of 6 mm and that are at
least 20 mm long.
18
En
A table or an area of the floor with adequate strength should
always be used to support the Plasma Television. Failure to do
so could result in personal injury and physical damage.
When installing the Plasma Television, please take the
necessary safety measures to prevent it from falling or
overturning in case of emergencies, such as earthquakes, or of
accidents.
If you do not take these precautions, the Plasma Television
could fall down and cause injury.
The screws, hooks, chains and other fittings that you use to
secure the Plasma Television to prevent it from overturning will
vary according to the composition and thickness of the surface
to which it will be attached.
Select the appropriate screws, hooks, chains, and other fittings
after first inspecting the surface carefully to determine its
thickness and composition and after consulting a professional
installer if necessary.
Using a wall for stabilization
1. Attach falling prevention bolts (hooks) to
2. Use strong cords to stabilize it
• Perform this work in the same way on the left and right sides.
Use hooks, cords, and fittings that are available on the market.
Recommended hook: Nominal diameter 8 mm
20 mm min.
Fitting
CAUTION
the Plasma Television.
appropriately and firmly to a wall, pillar, or
other sturdy element.
NOTE
Length 12 mm to 15 mm
➀ Hook
➁ Cord
12 mm to 15 mm