D-Link COVR-2600R User Manual page 65

Section 3 - Configuration
LAN IPv6 Address Settings
Enable DHCP-PD: Enable or disable prefix delegation services. This option is only
available if you selected Dynamic IP for address mode.
LAN IPv6 Link- Displays the router's LAN link-local address.
Local Address:
If Enable DHCP-PD is disabled, these additional parameters are available for
configuration:
LAN IPv6 Address: If DHCP-PD disabled, enter the LAN (local) IPv6 address for the router.
LAN IPv6 Link-
Displays the router's LAN link-local address.
Local Address:
Advanced Settings - Address Autoconfiguration Settings
Enable Automatic Enable or disable the Automatic IPv6 Address Assignment feature.
IPv6 Address
Assignment:
If DHCP-PD is enabled in LAN IPv6 Address Settings:
Enable Automatic Enable or disable DHCP-PD for other IPv6 routers connected to the
DHCP-PD in LAN: LAN interface.
Note: This feature requires a smaller subnet prefix than /64 (i.e. allowing
for a larger address allocation), such as /63. Contact your ISP for more
information.
Select SLAAC+RDNSS, SLAAC+Stateless DHCP, or Stateful DHCPv6.
Autoconfiguration
Type:
D-Link COVR-3902 User Manual
IPv6 in IPv4 Tunnel (continued)
61