Vctcxo Manual Tuning - Nokia 3155 Rf Description And Troubleshooting

3155/3155i (RM-41), 3152 (RM-61)
RF Description and Troubleshooting

VCTCXO Manual Tuning

The VCTCXO can be manually tuned to verify when a mobile terminal is tuned incorrectly
or if mobile terminal cannot make a call. Monitor the RF signal at the mobile terminal's
output.
1. On the Phone Control dialog box, click the LOCAL button in the Phone State
area to put the mobile terminal into Local Mode. (See
example of the Phone Control dialog box.)
2. Click the Execute button.
3. On the AMPS Control dialog box, set the Set Channel field to 384, the Power
Level field to 5, and select the Transmitter ON check box. (See
page 14
4. Click the Rx RFI tab, make sure the AFC Control check box is cleared, and click
Execute.
5. The frequency accuracy of the VCTCXO can be measured using an HP8960 callbox
in AMPS mode or a spectrum analyzer at the output of the transmit chain.
• If using a spectrum analyzer, set the center frequency to 836.52MHz and the
span to 2MHz initially. Establish a marker at 836.52Mhz.
• If using an HP8960, set the callbox System Type to AMPS, and set the ACC
channel to 384. Use the Frequency Stability measurement to center the
VCTCXO (minimum Frequency Error).
6. Use the RF PDM component to adjust the AFC to center the VCTCXO. The tuning
range is approximately +/-10kHz.
7. Adjust the AFC so that the output signal is within +/-150MHz. If using a
spectrum analyzer, narrow the span to 1kHz or less.
8. Replace the UEM if the VCTCXO does not tune correctly.
Page 50
for an example of the AMPS Control dialog box.)
©2005 Nokia Corporation
Figure 8
Company Confidential
on page 14 for an
Figure 9 on
ISSUE 1 07/2005