Advertisement
Cabinetry
Modification
Suggestions
Built-In
Ovens
Cut
rail
for
filler
panel
Cut the rail out of finished
material:
• The width should
match
cabinet
opening
width.
• The height
of the top rail should
be enough
to
securely
attach
the rail to the appearance
panel,
plus 1/4" oven trim overlap.
• The height
of the bottom
rail should
be enough
to
securely
attach
the rail to the appearance
panel,
plus 7/8" oven trim overlap.
• The height
of both
the top and bottom
rails should
be adjusted
depending
upon
the height
of the gap
to be filled or to enhance
appearance.
Top Rail
Length to Match
CabinetCutoutOpening
m
BottomRail
Lengthto Match
CabinetCutout Opening
Cut
appearance
panel
Determine
location
of cleats
Use drawer
fl'onts for appearance
panels
or cut
finished
material
and finish raw edges.
• The appearance
panel
width should
match
drawer
fronts
or doors.
• Make the appearance
panel
al)l)ropriate
height
to
fill the gap above or below the oven, allowing
for
reveals and overlaps
to match
existing
drawers
or
doors.
Width to Match
drawers or doors
FramedCabinet
Appeara/lcePanel
Mark Corners
with Pencil
Inside Front
of Cabinet
FramelessCabinet
Mark Corners
with Pencil
Inside Front
of Cabinet
•
To
find the exact position
of the cleats, place the
appearance
panel
onto
the cabinet
in desired
position
and align to match
the other
drawers
and
doors.
• Use a pencil
to mark the back side of the panel
where
it meets
the cabinet
corners.
14
Advertisement
