Safety Instructions - Pioneer DRC1227-A Operating Instructions Manual

SAFETY INSTRUCTIONS

To ensure your personal safety and to maximize the full operating potential of your Drive, read and follow
these safety precautions:
ENVIRONMENT - Avoid installing the unit in a location that is exposed to high temperatures, high humidity,
large quantities of dust, or subject to excessive vibrations and shocks.
POWER - Turn off the system before installing this unit or any other hardware device.
READ AND RETAIN INSTRUCTIONS - Read all safety and operating instructions before operating the unit.
CLEANING - Use a damp cloth to clean the exterior housing. Avoid using any fluids including aerosol, liquid,
or alcohol-based cleaning products.
WATER AND MOISTURE - DO NOT use this product near open containers or other possible sources of liquid.
POWER SOURCES - Operate this product only from the recommended power sources. If you are unsure of the
type of power available, consult an Authorized Pioneer Dealer.
OVERLOADING - DO NOT overload wall outlets and extension cords. Doing so can result in fire or electric
shock.
OBJECT AND LIQUID ENTRY - Never push objects of any kind into this product. Touching dangerous voltage
points may cause a short resulting in fire or electric shock. Do not spill any type of liquid on this product.
CONDENSATION - Moisture can form inside of the unit if it is moved between cool surroundings and a warm
environment. If you are moving the unit to a different room, leave the product disconnected in the new location
for up to 2 hours before installing the unit or turning it back on.
SERVICING - Do not attempt to repair this product yourself. Opening or removing covers may expose you to
dangerous voltage or other hazards. Refer all servicing to qualified service personnel. (Refer to the enclosed
Service and Support Card.)
÷ Avoid touching or scratching the signal surface (shiny
side) of the disc.
÷ Hold the disc by the edges or by the center hold and one
edge.
÷ Do not affix paper or labels to the disc.
÷ Discard warped or cracked discs as they may cause
damage to the drive.
÷ Avoid specially shaped discs such as hearts or polygons.
÷ Remove dust or lint from the disc with a soft cloth by
wiping from the inside to the outside edge rather than in
a circular motion.
÷ Do not use record-cleaning or anti-static agents as the
solutions may damage a disc.
Always store discs in proper DVD-R storage cases when
not in use. Check for dirt, dust, or fingerprints on a disc's
recording side before inserting in to the unit .
5
En