ABB S800 I/O User Manual page 116

Brr…hyÃDs‚…€h‡v‚ÃhqÃD†‡hyyh‡v‚ÃV†r…¶†ÃBˆvqr
6ƒƒrqv‘Ã6 Srsr…rpr†
Signal voltage output (in parallel with DCOK LED) is derived from the output terminal voltage, but
the device signal status is independent of external voltage injection from power supply units
connected in parallel.
The output voltage is adjustable within the range 22.5 Volts to 28.5 Volts, and is factory set at 24
Volts ±1%.
Primary voltage setting needs no selection or adjustment, the full voltage range specified is covered
by the design.
The modules can be mounted on a standard DIN rail. It has a mechanical latch that locks it to the
DIN rail. The latch can be released with a screwdriver.
UrpuvphyÃ9h‡h
Uhiyr 6  T9'
D‡r€
Output
Mains input voltage
Mains frequency
a.c.
d.c.
Rated input power, a.c.
Power factor
Rated input power, d.c.
Rated output power (at
24V)
Efficiency (50 - 100%
loading)
Power dissipation (full load) 11 W
Over-voltage protection
106
T9' !ÃQ‚r…ÃTˆƒƒy’ÃH‚qˆyrÃTƒrpvsvph‡v‚†
T9' ÃWhyˆrÃ
24V d.c. @ 2.5A
110 - 240V a.c.
185 - 250V d.c.
45 - 65 Hz
0 Hz
104 VA
0.67 typical
70 Watts
60 Watts
0.85
35V d.c.
T9' !ÃWhyˆr
24V d.c. @ 5.0A
110 - 240V a.c.
185 - 250V d.c.
45 - 65 Hz
0 Hz
207 VA
0.67 typical
140 Watts
120 Watts
0.85
22 W
35V d.c.
3BSE 020 923R101