Product Data Sheets - KitchenAid Architect Series II KDDC24RVS Installation Instructions And Use & Care Manual

This system has been tested according to ANSI/NSF 42/53 for the reduction of the substances listed below. The concentration of
the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for
water leaving the system, as specified in ANSI/NSF 42/53.
Substance Reduction NSF Reduction
Aesthetic Effects Requirements
≥50%
Chlorine Taste/Odor
≥85%
*
Particulate Class III
Contaminant NSF Reduction
Reduction Requirements
Lead: @ pH 6.5 0.01mg/L
Lead: @ pH 8.5 0.01mg/L
Mercury: @ pH 6.5 0.002 mg/L
Mercury: @ pH 8.5 0.002 mg/L
Benzene 0.0050 mg/L
p-dichlorobenzene 0.075 mg/L
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 63°F
(17.2°C).
It is essential that operational, maintenance, and filter
replacement requirements be carried out for the product to
perform as advertised.
Model WF-L200V: The filter monitor system measures the
amount of water that passes through the filter and alerts you
to replace the filter. When 90% of the filter's rated life is used,
the filter indicator light changes from green to yellow. When
100% of the filter's rated life is used, the filter indicator light
changes from yellow to red, and it is recommended that you
replace the filter. Use replacement cartridge L200V / NL120V,
part #4396702. 2010 suggested retail price of $32.99 U.S.A./
$49.99 Canada. Prices are subject to change without notice.
Model WF-NL120V: Change the water filter cartridge every 6-
9 months. Use replacement cartridge L200V / NL120V, part
#4396702. 2010 suggested retail price of $32.99 U.S.A./
$49.99 Canada. Prices are subject to change without notice.
The product is for cold water use only.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system.
* Class III particle size: >5 to <15 um
** Test requirement is at least 10,000 particles/mL of AC Fine Test Dust.
*** These contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.
® NSF is a registered trademark of NSF International.

PRODUCT DATA SHEETS

Base Grille Water Filtration System
Model WF-L200V Capacity 200 Gallons (757 Liters)
Model WF-NL120V Capacity 120 Gallons (454 Liters))
Tested and certified by NSF International against ANSI/NSF Standard
42 for the reduction of Chlorine, Taste and Odor, Particulate Class lll*;
and against ANSI/NSF Standard 53 for the reduction of Lead,
Mercury, Benzene, and p-dichlorobenzene.
Average Influent Challenge
Influent Concentration
1.9 mg/L 2.0 mg/L ± 10%
49,333/mL At least 10,000 particles/mL
Average Influent Challenge
Influent Concentration
0.14 mg/L*** 0.15 mg/L ± 10%
0.15 mg/L*** 0.15 mg/L ± 10%
0.0059 mg/L 0.006 mg/L ± 10%
0.0054 mg/L 0.006 mg/L ± 10%
0.0157 mg/L 0.015 ± 10%
0.210 mg/L 0.225 ± 10%
Maximum Average
Effluent Effluent
0.07 mg/L 0.06 mg/L
640 mg/L** 312 mg/L
Maximum Average
Effluent Effluent
0.0014 mg/L 0.0011 mg/L
0.0069 mg/L 0.0042 mg/L
0.0009 mg/L 0.0004 mg/L
0.0007 mg/L 0.00043 mg/L
0.002 mg/L 0.00083 mg/L
0.0005 mg/L 0.0005 mg/L
Refer to the front cover or "Accessories" section for the
Manufacturer's name, address and telephone number.
Refer to the "Warranty" section for the Manufacturer's limited
warranty.
Application Guidelines/Water Supply Parameters
Water Supply
Water Pressure
Water Temperature
Service Flow Rate
Minimum % Average %
Reduction Reduction
>75.0% >75.0%
98.7% 99%
Minimum % Average %
Reduction Reduction
99.0% 99.21%
95.4% 97.08%
84.74% 92.47%
87.03% 91.93%
87.26% 94.71%
99.76% 99.76%
City or Well
30 - 120 psi (207 - 827 kPa)
33° - 100°F (0.6° - 37.8° C)
0.5 GPM (1.89 L/min.) @ 60 psi.
17