Pioneer DV-585A-K Operating Instructions Manual page 51

Pioneer dvd player operating instructions dv-585a-s, dv-585a-k
Hide thumbs Also See for DV-585A-K:
Table of Contents

Advertisement

Additional information
Problem
Cannot play multi-
channel audio
Cannot listen to high-
sampling rate audio
through the digital
output.
Cannot output 192kHz or
176.4kHz digital audio.
Cannot output 96kHz or
88.2kHz digital audio.
No DTS audio output.
Audio mix does not
sound right or sounds
incomplete (for example,
inaudible dialog).
The audio recorded on a
Super VCD disc is not
output properly.
Can't hear effect of
Virtual Surround
Remedy
• Make sure that Audio Output Mode is set to 5.1 Channel
(page 40).
• Check that the Dolby Digital, DTS and MPEG Out settings
(pages 34–35) are suitable for your amplifier/receiver—check the
instruction manual that came with your amplifier/receiver.
• DVD-Audio and SACDs do not output multichannel digital audio.
Listen through the player's analog outputs.
• Check that the settings in the Speaker Installation screen are
correct (page 43).
• Check the audio options available from the disc menu.
• Make sure that Linear PCM Out is set to Downsample Off
(page 35).
• As a copy-protection measure, some DVDs do not output 96kHz
audio. In this case, even if set to Downsample Off, the player
automatically outputs the audio at 48 kHz. This is not a malfunction.
• The player does not output digital audio at these sampling rates. The
digital output is automatically downsampled.
• Check that Linear PCM Out is set to Downsample Off (page 35).
• Some discs are digital copy protected and do not output high
sampling rate digital audio. In this case the output is automatically
downsampled.
• If this unit is connected to a non-DTS compatible amplifier or
decoder using a digital audio cable, set DTS Out to DTS
(page 34). If you do not do this, noise will be output when you play a
DTS disc.
• If this unit is connected to a DTS-compatible amplifier or decoder
using a digital audio cable, check the amplifier settings, and that the
cable is properly connected.
• Make sure that Audio Output Mode is set to 2 Channel if you've
connected to the stereo inputs on your amplifier or TV (page 40).
• If the audio is switched to [2] when playing a Super VCD that
contains only one stereo soundtrack, there may be no sound at all.
Press AUDIO to change the soundtrack.
• Virtual Surround does not work with SACD or DVD-Audio.
• The Virtual Surround effect is only output through the AUDIO OUT
(2ch) analog audio outputs.
• Make sure that Audio Output Mode is set to 2 Channel (page 40).
• The effectiveness of Virtual Surround varies with the disc.
08
>
PCM
51
En

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dv-585a-s

Table of Contents