Control Options: Get To Know Your Flat Panel Display; Control Buttons And More On The Flat Panel Display - Pioneer Kuro Elite PRO-101FD Operating Instructions Manual

Introduction to the Flat Panel Displays

1.2 Control Options: Get to Know Your Flat Panel Display

You can operate your flat panel display from the panel buttons or with the remote control. The following sections
provide button locations/operations for the panel and the remote control.
1.2.1

Control Buttons and More on the Flat Panel Display

Your flat panel display has buttons, indicators, and sensors on the lower front bezel with more buttons on the rear
panel. Refer to the drawings below for specific locations and functions. Or, to identify back ports and terminals
only, check the terminal position sheet located near the panel's terminal compartment.
1 2
1 - Power On indicator
2 - STANDBY indicator
3 - Power On () button
4 - Room Light sensor
5 - Remote Control sensor
(upper bank)
1 2
(from left to right)
1 - INPUT 1 terminal (Video)
2 - INPUT 2 terminals (Component, Y, C
3 - INPUT 3 terminal (Analog RGB)
4 - INPUT 4 terminal (DVI-D)
5 - INPUT 5 terminal (HDMI)
6 - INPUT 6 terminal (HDMI)
Terminals on the rear panel are common to both models.
PRO-141FD/PRO-101FD: Face of Panel
3 4
Back of the Panel
3 4 5 6
/P , C /P )
B B R R
9
5
6 7 8
PRO-101FD
(Bottom of the rear panel)
6 - STANDBY/ON button
7 - SCREEN SIZE button
8 - INPUT buttons
9 - Bezel (some call it the front frame)
7 8 9 10
7 - INPUT 7 terminal (HDMI)
8 - INPUT 8 terminal (HDMI)
9 - RS-232C terminal (for factory use)
10 - LAN terminal
11 - IR REPEATER OUT terminal
12 - AC In terminal
8
7
6
PRO-141FD
(Right side)
11 12
01
7
En