Power Cord Connection; How To Route Cables - Pioneer PDP-502MXE Operating Instructions Manual

Pioneer corporation operating instructions plasma display pdp-502mxe
Hide thumbs Also See for PDP-502MXE:
Table of Contents

Advertisement

Installation and Connections

Power cord connection

Connect a power cord after all component connections
have been completed.
PDP-502MXE power cord ratings
Cord .......................... Cross-sectional area 3 x 1.0 mm
Connector ................................................... 10 A, 250 V
(According to EN60320 Sheet C13)
Plug ................................ International use (10 A, 250 V)
Example:
UK
: UK 13 Amp Plug with rated 13 Amp fuse
(According to BS1363)
EURO : 10 A/16 A 250 V (According to CEE 7, 1 V)
CAUTION
÷ Do not use a power supply voltage other than that indicated
(AC 100 - 240 V, 50/60 Hz) as this may cause fire or electric
shock.
÷ For the plasma display, a three-core power cord with a ground
terminal is used for efficiency protection. Always be sure to
connect the power cord to a three-pronged grounded outlet
and make sure that the cord is properly grounded. If you use a
power source converter plug, use an outlet with a ground
terminal and screw down the ground line.

How to route cables

Speed clamps and bead bands are included with this unit
for bunching cables together. Once components are
connected, follow the following steps to route cables.
1
12
<ARE1350> En
2
(According to CEE 13)
1
2
1
Organize cables together using the provided
speed clamps.
Insert 1 into an appropriate hole on the rear of the
unit, then snap 2 into the back of 1 to fix the clamp.
Speed clamps are designed to be difficult to undo
once in place. Please attach carefully.
To attach the speed clamps to the main unit
Connect the speed clamps using the 4 holes marked with
• below, depending on the situation.
To remove speed clamps
Using pliers, twist the clamp 90° and pull it outward.
In some cases the clamp may have deteriorated over
time and may be damaged when removed.
2
Bunch separated cables together and secure
them with the provided bead bands.
Note
Cables can be routed to the right or left.
* As viewed from the rear of the display.
2

Advertisement

Table of Contents
loading

Table of Contents