Mount point change of installation frame from the rear to the front
The upper and lower installation frames are attached on the inverter (one for each position).
Change the mount point of the upper and lower installation frames from the rear to the front as shown in the figure.
When reattaching the installation frames, make sure that the installation orientation is correct.
Installation of the inverter on the enclosure
Push the inverter heat sink part outside the enclosure, and fix the inverter to the panel with upper and lower installation frames.
• As the heat sink part protruded through the panel includes a cooling fan, this type of installation is not suitable for the
environment of water drops, oil, mist, dust, etc.
• Be careful not to drop screws, dust etc. into the inverter and cooling fan section.
There are finger guards behind the enclosure.
Therefore, the thickness of the panel should be
less than 10 mm (*1) and also do not place
anything around finger guards to avoid contact
with the finger guards.
the outside of
2. INSTALLATION AND WIRING
2.3 Installation of the inverter and enclosure design