Table Of Contents - Sony RM-AX4000 Service Manual
Integrated remote commander
Hide thumbs
Also See for RM-AX4000:
- Software manual (118 pages) ,
- Operating instructions manual (96 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
RM-AX4000
TABLE OF CONTENTS
1.
................................................................... 3
2.
2-1. CASE (Lower) ................................................................. 7
2-2. KEY Board and LCD Section ......................................... 7
2-3. MAIN Board and LCD Module ...................................... 8
3.
............................................................... 9
4.
4-1. Block Diagram - MAIN Section - .................................. 12
4-2. Printed Wiring Board - MAIN Board - .......................... 13
4-3. Schematic Diagram - MAIN Board - ............................. 14
5.
6.
2
................................................. 17
.................................. 18
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 °C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscou-s (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder. Operating instructiondd
Advertisement
Table of Contents
