Belt Replacement - Craftsman 247.88976 series Operator's Manual

Chute
If the chute fails to remain stationary during operation, the pre-load of the chute
can be adjusted by tightening the hex nut found on the front of the chute control
head.
1. To increase the preload, tighten the hex nut clockwise in ¼ turn intervals.
See Figure 66.
2. If the chute directional control is difficult to crank, decrease the preload by
loosening the hex nut counterclockwise in ¼ turn intervals.
Auger Control
Refer to the Assembly section for instructions on adjusting the auger control cable.
Skid Shoes
Refer to the Assembly section for instructions on adjusting the skid shoes.
SERVICE AND MAINTENANCE
Figure 66

Belt Replacement

Auger Belt
To remove and replace your snow thrower's auger belt, proceed as follows:
1. To prevent spillage, remove all fuel from tank by running engine until it
stops.
2. Remove the plastic belt cover on the front of the engine by removing the two
self-tapping screws. See Figure 67.
3. Roll the auger belt off the engine pulley. See Figure 68.
4. Carefully pivot the snow thrower up and forward so that it rests on the auger
housing.
33
Figure 67
Figure 68